최신 AMPP-SICT Senior-Internal-Corrosion-Technologist 무료샘플문제:
1. Dehumidification is defined as the removal of moisture vapor from the air to
A) lower Its temperature.
B) raise its relative humidity.
C) provide worker comfort
D) lower Its dew point.
2. You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed.
The specification references SSPC SP 16 as the surface preparation method. At the pre-Job meeting operations personnel make it dear that abrasive blasting will not permitted. The Owner's representative asks you what other methods might be used. Of the options shown below, what would be the preferred option in this situation?
A) SP 1 followed by acid etching
B) SP 1 followed by SP 3
C) SP 1 followed by caustic etching
D) SP 1 followed by SP 2
3. When performing Inspection in accordance with ASTM D 4138 the Inspector will use:
A) A mechanical adhesion tester
B) A set of 14 pencils of varying hardness
C) A hardness tester
D) A destructive paint inspection Tooke gauge
4. The standards defining surface cleanliness achieved by centrifugal blast cleaning are:
A) Different than air blast cleaning
B) Comparable to air blast cleaning
C) The same as air blast cleaning
D) Slightly different to air blast cleaning
5. A reinforced coating is
A) equally resistant to movement and impact as a non-reinforced coating.
B) less resistant to movement, abrasion, and impact than a non-reinforced coating.
C) more resistant to movement, abrasion, and impact than a non-reinforced coating.
D) equally resistant to abrasion and impact as a non-reinforced coating.
질문과 대답:
| 질문 # 1 정답: D | 질문 # 2 정답: A | 질문 # 3 정답: D | 질문 # 4 정답: C | 질문 # 5 정답: C |
1101 개 고객 리뷰
품질과 가치ITCertKR 의 높은 정확도를 보장하는 최고품질의 덤프는 IT인증시험에 대비하여 제작된것으로서 높은 적중율을 자랑하고 있습니다.
테스트 및 승인ITCertKR 의 덤프는 모두 엘리트한 전문가들이 실제시험문제를 분석하여 답을 작성한 만큼 시험문제의 적중률은 아주 높습니다.
쉽게 시험패스ITCertKR의 테스트 엔진을 사용하여 시험을 준비한다는것은 첫 번째 시도에서 인증시험 패스성공을 의미합니다.
주문하기전 체험ITCertKR의 각 제품은 무료 데모를 제공합니다. 구입하기로 결정하기 전에 덤프샘플문제로 덤프품질과 실용성을 검증할수 있습니다.
