최신 Nutanix Certified Master NCM-MCI5.15 무료샘플문제:
1. An administrator receives reports that VDI desktop performance in an 8-node Nutanix VDI environment is poor. Opening applications takes between 1 and 2 minutes.
When investigating the issue, the following conditions are found:
* Cluster memory utilization: 80%
* Cluster SSD utilization: 70%
* Average VM CPU Wait Time: 11%
* CVM CPU utilization: 75%
Which action should be taken to improve VDI performance?
A) Increase the amount of SSD storage in the cluster.
B) Add CPU resources to the cluster.
C) Increase the number of vCPU cores allocated to the CVM.
D) Add memory to the nodes in the cluster.
2. Refer to the exhibit.
An administrator notices a critical alert on the Metro Availability Protection Domain What is causing this alert?
A) Metro Availability did not fail over and caused an outage.
B) vSphere moved VMs to the remote container, and the VMs must be moved back.
C) Metro Availability Protection domain is active on the remote site.
D) VMware Site Recovery Manager is handling a failover event
3. A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?
A) The customer has the ability to add more VMs up to the 100% storage utilization.
B) There is available capacity in the storage fabric and the cluster is resilient.
C) The cluster is not resilient in the storage fabric
D) Node failure is imminent due to storage utilization.
4. An administrator is supporting a business critical environment and deploys metro availability to achieve a zero data loss configuration. The two clusters are connected by a 1GbE connection. A new workload is going to be deployed to this cluster. This workload requires a sustained 150MB/S of write throughput and 20MB/s of read throughput.
Which change must be made to deploy the workload successfully on this cluster?
A) The bandwidth must be increased to support this workload.
B) Zero data loss nearsync must be used to support this workload.
C) The workload must be configured to read at greater than 12.5MB/S.
D) The replication frequency must be less than 60 minutes.
5. A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected 5-minute interval.
What should the customer do to enable the snapshots to happen at the expected interval?
A) Configure the protection domain to take snapshots on 15-minute intervals
B) Utilize Metro Availability to meet this requirement
C) Change the protection domain to use Async DR
D) Fix a connectivity issue because the protection domain reverted to Async
질문과 대답:
| 질문 # 1 정답: B | 질문 # 2 정답: C | 질문 # 3 정답: C | 질문 # 4 정답: A | 질문 # 5 정답: D |
1333 개 고객 리뷰
품질과 가치ITCertKR 의 높은 정확도를 보장하는 최고품질의 덤프는 IT인증시험에 대비하여 제작된것으로서 높은 적중율을 자랑하고 있습니다.
테스트 및 승인ITCertKR 의 덤프는 모두 엘리트한 전문가들이 실제시험문제를 분석하여 답을 작성한 만큼 시험문제의 적중률은 아주 높습니다.
쉽게 시험패스ITCertKR의 테스트 엔진을 사용하여 시험을 준비한다는것은 첫 번째 시도에서 인증시험 패스성공을 의미합니다.
주문하기전 체험ITCertKR의 각 제품은 무료 데모를 제공합니다. 구입하기로 결정하기 전에 덤프샘플문제로 덤프품질과 실용성을 검증할수 있습니다.
