최신 JNCIA JN0-321 무료샘플문제:
1. Which configuration parameters are needed to configure this SLB group on the JuniperDX?
A) listen VIP, listen port, target host IP addresses, SSL certificates
B) listen VIP, listen port, protocol, target host IP addresses, target host ports
C) listen VIP, listen port, target host IP addresses, client ports
D) listen VIP, listen port, target host IP addresses, preferred load balancing policy
2. Your company has two identical intranet servers which run both HTTP and HTTPS. You need to deploy the Juniper DX in front of these servers maintaining the existing mix of protocols. Which statement is true?
A) You will need to create four Clusters, one for each server and each protocol.
B) You will need to create a Cluster and a Redirector.
C) You will need to create a single Cluster which uses both protocols.
D) You will need to create two Clusters, one for each protocol.
3. What are two uses of the AS Path attribute?
A) route selection
B) loop avoidance
C) determining equal cost paths for reachability
D) defining the application of other BGP attributes
4. In which section of the WebUI does the administrator create and apply AppRules?
A) Cluster
B) SLB
C) Redirector
D) Forwarder
5. A RIPv1 Response message includes which of the following fields?
A) neighbor address
B) destination address
C) gateway address
D) next hop address
질문과 대답:
질문 # 1 정답: B | 질문 # 2 정답: D | 질문 # 3 정답: A,B | 질문 # 4 정답: A | 질문 # 5 정답: B |