최신 Avaya Specialist 6101.1 무료샘플문제:
1. A switch duster core composed of two Ethernet Routing Switch (ERS) 8600 switches has been property configured to supports new edge switch stack 802.1Q correctly configured on the edge switch stack.
What will the switch core do with packets arriving from this edge stack?
A) it will place them m the data VLAN.
B) Pace them in the default VLAN (VLAN1)
C) It will forward the packets to the Switch CPU.
D) It will discard the packets
2. Which two pairs of commands will configure spanning tree on the edge switch? (Choose two)
A) 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning tree learning disable
B) 5520-24T (config) # interface fastethernet 25-26 5520-24T (corrfig-if) # spanning-tree learning fast
C) 5520-24T (config) # interface fastethernet 1-20 5520-24T (config-if) # spanning-tree learning fast
D) 5520-24T (config) # interface fastethernet 25-26 5520-24T (config-if) # spanning tree learning disable
3. Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)
A) RSML T dynamically balances the CPU load across the switch cluster.
B) RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.
C) RSMLT edge is easier to configure and lightens the CPU load,
D) the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.
E) RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.
4. What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?
A) 24
B) 16
C) 50
D) 48
5. A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available.
Which statement is correct?
A) The customer can set the switch to use the temporary address of 192.168.192.168 by pressing the User Interface button on the front of the ERS 2550T
B) To communicate with an ERS 2550T the IP address must first be set though the console interface.
C) The customer can connect to the network management Ethernet port which is pre-configured to use the 192 168 1 1/24 IP address
D) The switch will first attempt to use BootP to acquire an IP address, and if that fails it will assign IP address 192.160.1.1/24 to the switch IP.
질문과 대답:
| 질문 # 1 정답: A,C | 질문 # 2 정답: A,B | 질문 # 3 정답: C,E | 질문 # 4 정답: D | 질문 # 5 정답: C |
637 개 고객 리뷰
품질과 가치ITCertKR 의 높은 정확도를 보장하는 최고품질의 덤프는 IT인증시험에 대비하여 제작된것으로서 높은 적중율을 자랑하고 있습니다.
테스트 및 승인ITCertKR 의 덤프는 모두 엘리트한 전문가들이 실제시험문제를 분석하여 답을 작성한 만큼 시험문제의 적중률은 아주 높습니다.
쉽게 시험패스ITCertKR의 테스트 엔진을 사용하여 시험을 준비한다는것은 첫 번째 시도에서 인증시험 패스성공을 의미합니다.
주문하기전 체험ITCertKR의 각 제품은 무료 데모를 제공합니다. 구입하기로 결정하기 전에 덤프샘플문제로 덤프품질과 실용성을 검증할수 있습니다.
